![]() ![]() ![]() I had mine upside down and it took me a while to figure out why it wasn't working, but after flipping my battery around, I was able to use the keyboard. Make sure the battery in the remote control is positioned correctly. Plugged it into a Windows box and it detected my little card. Step 4: Plug the USB stick into your Boxee Box and start it (plugin powersupply, press power button). ![]() Step 3: From the downloaded hack file, copy the contents of the install folder on the USB stick. I took off the extra wires off the Boxee Box plug and wired the red, white, green, black wires to the same red, white, green, black wires on the USB cable. Step 2: Partition a USB stick to one Partition, formatted MS-DOS FAT and name it BOXEE (all capitals, no quotes). Then I removed the 0-ohm resistor from JR1's pads 1 and 2 and soldered a small wire in between pads 2 and 3 so I can feed 5V from the USB cable directly to VBUS. Cet appareil a donn lieu en 2006 une controverse entre deux des grands mentors du logiciel libre, Richard Stallman et Linus Torvalds, dbouchant sur la cration du nologisme tivoisation et d'une nouvelle version de la licence GPL, la version 3, destine viter aux logiciels sous licence GPL de subir les mmes cueils que les logiciels sous GPLv2. The first thing you will have to do is to gain root access to the Boxee Box, and to do that you need to install 'Boxee+Hacks' which does exactly that. I didn't care about my old Boxee Box any more, so after throwing away the little wireless card, I also removed the cable in the Boxee Box so I could use it to wire the connector to my USB cable instead of soldering the wires onto the board. No need to whip up any circuits at all!! Just need a soldering iron, a USB cable, a wire and some time. This was much simpler than I thought after reading thru the comments here. ![]()
0 Comments
Leave a Reply. |